cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

Hi,

   

I was curious as to how the -3 dB Frequency was calculated for the transimpedance amplifier. The Data sheet says that this is calculated based on

   

f -3dB = 1/ (2*pi* Rfb* Cfb)

   

Which is not actually the case for the autocalculated value in the TIA configuration menu.

   

for example, with:

   

Rfb = 20k

   

Cfb = 4.6 pF,

   

the cutoff frequency should be about 1 729 945.03 Hz ? but the autocalculated value is 866 kHz...

   

perhaps someone can shed some light on this?

   

Thanks!

0 Likes
Reply
1 Reply
Anonymous
Not applicable

From what I observe, the calculation of bandwidth of TIA is dependent not only on the feedback resistor and feedback capacitor, but also on the power setting selected.

   

 

   

The bandwidth is definitely inversely proportional to the product of resistor and capacitor. But if the power mode is set to "High Power", then the Bandwidth is higher. But if the power setting is set to "Minimum Power", then the Bandwidth is miniumum.

0 Likes
Reply