There was an error running port acquire using USB conection

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello,

   

I am working with the CY8CKIT-050 PSoc 5LP Development Kit. It was working ok but when I put it a 9v battery they stop to run his program. Because of that I conected again to the PC and try to program it again but gave me this error :

   

 

   

There was an error running port acquire. There may be no devices attached, or a device may be in use by another application.

   

 

   

I am using the USB to program it, and I don't know hou to solve it.

   

 

   

best

0 Likes
6 Replies
ETRO_SSN583
Level 9
Level 9
250 likes received 100 sign-ins 5 likes given

I am out of time, so take a look at board schematic to see if

   

you hosed anything by not changing jumpers when you connected

   

battery. Some regulators will not take sink current w/o damage, verify

   

that could not have happened by looking at datasheet if board does not

   

porotect against reverse current with a diode.....

   

 

   

Regards, Dana.

0 Likes
Anonymous
Not applicable

 Thanks Dana, I am going to take a look.

   

 

   

Best

0 Likes
Anonymous
Not applicable

 Dana, 

   

I take a look of the schematics, but there is a diodo that protects the circuit. And Important thing that I didn't said at the begining it was that i have been useing the battery for a long period, it wasn't the first time that I put it.

   

best

0 Likes
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

I admit that it might be a silly question, but do you use the correct USB-port of the Kit-050?

   

 

   

Bob

0 Likes
Anonymous
Not applicable

 Yes I am using the correct usb port, I have 3 mouth working with this kit. And this is the first time that happen.

   

best

0 Likes
Anonymous
Not applicable
        Hi did u solve the problem? I came across that.   
0 Likes