- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I want to read the temperature from a 1-Wire based digital thermometer DS18B20 and show it using UART communication. Can you tell me
how to do it as PSoC Creator 4.2 has no 1-Wire component?
I am using CY8CKIT-059PSoC5LP
best regards,
NA
Solved! Go to Solution.
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Someone actually created a custom component to interface with that sensor:
Component to read DS18B20 digital temperature sensors
Without this though, you'd have to write the read/write functions in the firmware.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Someone actually created a custom component to interface with that sensor:
Component to read DS18B20 digital temperature sensors
Without this though, you'd have to write the read/write functions in the firmware.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Another bit banging example you can have a look at
PSoC4: Bit Banging 1 Wire Protocol (DS18B20 Thermometer) - Hackster.io
Best Regards,
Vasanth