- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the parameters window of PWM8 user module, set the "compare out" as Row0_Output0. Then, click on LUT on that row and click on the buffer which connects to GlobalOutEven4 (GOE 4). Then click on globalOutEven4 line and select the "pin" as P0[4].
Please see attached PDF file for example.
-Rajiv Badiger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The DC( ) sets duty cycle in percent, not angle. So you have to use datasheet of
servo to figure out what DC you need to get what angle. Nominally a servo runs
a PW of 1 - 2 mS in a 20 mS period, so
1 mS =~ - 90 = 5% DC
1.5 mS =~ 0 = 7.5% DC
2 mS =~ + 90 = 10% DC
Are you still using Atmet UP to do this ?
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Do you have any tools to meansure the output of PSoC?
Hoiw about
while (1){
turn on P0_0;
delay 5 seconds;
turn off P0_0;
delay 5 seconds,
}
If you have a CRO, use the CRO to check what is the output level of P0_0.
If no CRO, then use a mutlimeter to see if the output does change. This should confirm if the output of PSoC is not dead and in the right drive mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
unfortunately I don't have osciloscope to see what happened here...
yes, I'm still using atmel, and still work well for me,
try to migrate to cypress but no luck until now...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HELLO I am new here i have a problem with my project
i have 5 servo (type 9g) i want to control them by ADC in my Psoc 5lp card (0 TO 180 ° )
the secound part of my project it to use UART data to controle another card Psoc 5lp (to controle a hand)
thnks and sorry for my English
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum.
Not a good idea to hijack a 4 year old thread in the wrong forum. Better re-post in PSoC5 forum as a new thread. This will ensure that the right "Gurus" see your question.
I can assure you that your PSoC5 is able to control those servos.
Bob