Anonymous
Not applicable
May 24, 2018
10:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 24, 2018
10:34 PM
hi
Good morning
I have problem with Psoc programmer when I connect it in to my custom board .In Select debug target window it shows device is Cortex m3 but some time it shows device name with warning symbol in .we are using CY8C5868-AXI-LP035 controller.Our programmer is working fine on another type custom board.Here I attached my circuit with this question.
Solved! Go to Solution.
Labels
1 Solution
May 27, 2018
06:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2018
06:51 PM
Which debugger are you using?
Try to use a shorter cable to check if it can help.
This KBA is FYI Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619
1 Reply
May 27, 2018
06:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2018
06:51 PM
Which debugger are you using?
Try to use a shorter cable to check if it can help.
This KBA is FYI Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619