Attachments are accessible only for community members.
Anonymous
Not applicable
Apr 03, 2015
07:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 03, 2015
07:25 PM
Hello!!! I am a super noob when it comes to PSoC. I am working to get the Filter_ADC_VDAC_poll example project running on my PSoC 5LP. It says in the documentation that I need to "Set SW3 to 5V and leave the rest of the board at default configuration." I have found where it says sw3 on the board but it isn't a switch, it is a button. What do I need to do on the 5LP so that I can configure this kit correctly? Thanks for you help!!!
Labels
- Labels:
-
PSoC 5LP
3 Replies
Apr 03, 2015
08:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 03, 2015
08:08 PM
SW3 applies only to the CY8CKIT-001. For the other
kits just insure the power jumpers set up to 5V.
Regards, Dana.
Anonymous
Not applicable
Apr 03, 2015
08:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 03, 2015
08:42 PM
Thanks Dana, I finally found the PSoC 5 Development Kit Guide. I don't know why it was so hard to find. I see where you are pulling from. Thanks!!!
Apr 04, 2015
05:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2015
05:09 AM
Glad to have been of assistance.
Regards, Dana.