cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

I would like to copy SRAM data via DMA to the datapath FIFO. I am using the Datapath configurator. I want to use the FIFO F0.

   

So my plan was to use the f0_bus_stat signal to trigger the next DMA transfer if the FIFO is not full. The DMA is outside of this component.

   

I defined an output FIFObus_stat and mapped the signal f0_bus_stat to it -> ERROR invalid identifier

   

So what's the correct name of the f0_bus_stat signal?

   

 

   

Is there an example available that just shows what i want to do?

0 Likes
1 Solution
Anonymous
Not applicable

sorry, 2 min after posting i found the solution, you need to define this in the "Configure Datapath Outputs"

View solution in original post

0 Likes
1 Reply
Anonymous
Not applicable

sorry, 2 min after posting i found the solution, you need to define this in the "Configure Datapath Outputs"

View solution in original post

0 Likes