Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

I would like to copy SRAM data via DMA to the datapath FIFO. I am using the Datapath configurator. I want to use the FIFO F0.

   

So my plan was to use the f0_bus_stat signal to trigger the next DMA transfer if the FIFO is not full. The DMA is outside of this component.

   

I defined an output FIFObus_stat and mapped the signal f0_bus_stat to it -> ERROR invalid identifier

   

So what's the correct name of the f0_bus_stat signal?

   

 

   

Is there an example available that just shows what i want to do?

0 Likes
1 Solution
Anonymous
Not applicable

sorry, 2 min after posting i found the solution, you need to define this in the "Configure Datapath Outputs"

View solution in original post

0 Likes
1 Reply
Anonymous
Not applicable

sorry, 2 min after posting i found the solution, you need to define this in the "Configure Datapath Outputs"

View solution in original post

0 Likes