Attachments are accessible only for community members.
Anonymous
Not applicable
Dec 22, 2017
03:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 22, 2017
03:37 AM
Hi there,
I'm trying to communicate with an external ADC. Therefore I use SPI with manual SS control. To emulate the ADC a took a SPI slave next the SPI Master on the top design. When setting the clock speed to 1kHz, I see the expected result on the LCD, but when increasing the speed to 1MHz or higher I get corrupted data.
I attached my workspace bundle and a picture of my setup wth the expected result on LCD. It would be nice if someone could take a look at my code and eventually find my mistake.
Greetings from Fabian
Labels
2 Replies