- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have an option to run the code from SRAM in PSoC 5. Is there a similar option in PSoC 3 to run the code from SRAM. How do I do it?
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To my understand. PSoC3 cannot excute code in RAM.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just wondering if PSoC4 can have code excute in RAM?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Answer is yes, PSOC 4 and 5 address space is linear, modified von neumann, as opposed to
PSOC 3, Harvard.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did John von Neumann study at Harvard? (smiley)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In ARM Cortex-M3 architecture, lower 0.5GB (0x00000000 – 0x1FFFFFFF) represents code memory.
In PSoC 5LP, lower 32KB SRAM is present in 0x1FFF8000 – 0x1FFFFFFF memory location which is in code memory space of CM3. That is why it is possible to execute the code from SRAM provided that code is stored in this lower 32KB of SRAM space.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In PSoC 4, 4KB of SRAM starts from 0x20000000 location only which is not in Code space region. So, it is not possible to execute code from SRAM of PSoC 4 which is possible in PSoC 5LP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This seems to support it as well -
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think we should move this thread to PSoC4 sub forum.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
In PSoC 5LP, it is possible to place a code in the upper SRAM region (i.e) above the address 0x2000000. Similarly in PSoC 4, it is possible to possible to place a code in the upper SRAM region. There is no limitation that the code in the upper SRAM region cannot be exectued.
Regards,
Asha