Anonymous
Not applicable
Aug 12, 2009
11:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2009
11:50 PM
I have enabled only RXE and RXC interrupts, but my code gets to a point during communication where the interrupt keeps firing because the IRQ line is asserted but when RX_IRQ_STATUS_ADR is read, it shows RXBERR_IRQ is high while RXC and RXE are low. I haven't enabled RXBERR interrupts, so why does the interrupt keep firing? Is there anything else that will cause the interrupt no matter what my settings are?
Labels
- Labels:
-
PSoC 1
1 Reply
Anonymous
Not applicable
Aug 19, 2009
09:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 19, 2009
09:28 PM
Looks like I had corrupted the registers. No problems now. Thank You.