Anonymous
Not applicable
Jun 14, 2018
06:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2018
06:53 PM
Can I program the CY8c24894 using the miniprog3 ? It doesn't seem to be listed in the miniprog3 device family list.
If yes, is there a way to load the CY8C24894 family to the miniProg3 SW app?
Thanks
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 1
-
PSoC 1 Device Programming
1 Solution
Jun 14, 2018
07:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2018
07:53 PM
You may try with switching the Protocol from SWD(default) to ISSP.
Roy Liu
2 Replies
Jun 14, 2018
07:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2018
07:53 PM
You may try with switching the Protocol from SWD(default) to ISSP.
Roy Liu
Anonymous
Not applicable
Jun 14, 2018
08:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2018
08:22 PM
Thanks Very much Yliu, that was it