Aug 15, 2018
05:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 15, 2018
05:07 PM
Hi
I have been using PSoC Creator 4.2 to program several CY8CKit 059 boards. I jusr received some new (hopefully idential) boards. When I try to program it in the same way, the Select Debug Target dialog pops up but it shows the KitProg and a sub item called ARM Debug Port (which the previous units did not show). When I hit Port Acquire, it finds the ARM Debug port and reports that it cannot program it.
As far as I can see, the boards are the same (both REV006)
How can I program my new boards?
Dave
Solved! Go to Solution.
Labels
1 Solution
Aug 15, 2018
08:44 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 15, 2018
08:44 PM
Try to use the programmer to download your hex to the device.
Where do you get these kits?
Could you add your config figure in the programmer screen shot here.
3 Replies