cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

Respected Members,

(1) What would be the best way to initiate a communication between FPGA and PSoC5-LP.

Actually, I want to utilize the ADC and OP-AMPS in PSoC-5LP and send data output from these modules to FPGA for further manipulation.
Following are the two devices that I am using in my design.

   

http://www.cypress.com/documentation/development-kitsboards/cy8ckit-059-psoc-5lp-prototyping-kit-onb...

http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/LatticeXP2Brevia2DevelopmentKit.aspx
 

   

(2) Lastly, is there any way to extend the crystal of above-mentioned PSoC5-LP prototype kit? i.e. from 80 MHz to 150 MHz or any other higher frequency? 

0 Likes
Reply
3 Replies
Esteemed Contributor II

1) You may use the SPI or the UART interface your Lattice board has got.

   

2) No way for a PSoC

   

 

   

Bob

0 Likes
Reply
Anonymous
Not applicable

Thanks for your prompt reply.

0 Likes
Reply
Esteemed Contributor II

You are always welcome.

   

 

   

Bob

0 Likes
Reply