- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Respected Members,
(1) What would be the best way to initiate a communication between FPGA and PSoC5-LP.
Actually, I want to utilize the ADC and OP-AMPS in PSoC-5LP and send data output from these modules to FPGA for further manipulation.
Following are the two devices that I am using in my design.
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-059-psoc-5lp-prototyping-kit-onb...
http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/LatticeXP2Brevia2DevelopmentKit.aspx
(2) Lastly, is there any way to extend the crystal of above-mentioned PSoC5-LP prototype kit? i.e. from 80 MHz to 150 MHz or any other higher frequency?
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1) You may use the SPI or the UART interface your Lattice board has got.
2) No way for a PSoC
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your prompt reply.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are always welcome.
Bob