Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

suleymaniye
New Contributor

I'm using CY8C29666 to generate two inverted PWM signals. That worked fine.

Now I want to enable and disable that PWM block using other PWM with much lower clock, like I show in the image.

suleymaniye_0-1623173148318.png

I connected the enable input of my PWMDB to the output of the other PWM,  but this is not working.

Previously, I've used a Counter to feed the Clock signal to an UART, so I expected this to work. Am I missing something on this? Any information would help.

Thanks

0 Likes
1 Reply
SampathS_11
Moderator
Moderator

Hello @suleymaniye ,

For troubleshooting this issue, can you kindly change the clock of PWMDB8_1 to VC2, and check if the PWMDB8 counts when enabled?

Best regards,

Sampath Selvaraj

0 Likes