- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear all,
I have a new board based on CY8C5468AXI-LP106 device. After 10-20 minutes the chip gets hot and the power consumption in the external power supply goes from a few mA to hundred of mA and chip gets hot. During this time I can program and debug the board using miniprog3.
I have revised the schematic and checked symbols and footprints of all components and do not see any thing wrong.
I attache schematic and some screenshots of the PSOC Creator if you want to have a look. On the Schematic, FILA_X are digital outputs, and COL_X are analogue inputs going to an internal AMUX/ADC. The Power supply is 9V and with two regulators goes down to 5V and 3V3.
Could you please have a look and check if there is anything wrong? have anyone an idea what can be the problem?
Thanks in advance,
Joaquin
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, thank you, very much.
I dont understand how can it happen but is the most probably cause of this.