Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable
‎May 14, 2010 09:49 AM

NOISE IN THE SECOND COLUMN

        I found my second column SC and CT Blocks produce noise. I realised doind followers and I try to reduce the column clock. The SC blocks works until 2MHz, so I decreades from 1MHz to 200KHz. Is it possible my part would be damaged or I'm setting wrong any parameter?   
Labels
0 Likes
Reply
1 Reply
Anonymous
Not applicable
‎May 14, 2010 04:01 PM

Re: NOISE IN THE SECOND COLUMN

The switched capacitor network product inherent noise. I do not think your part is damaged. We actually speced the noise by frequency in analog blocks in datasheet. Check out the "5V AC Operational Amplifier Specifications" table uder the "AC Operational Amplifer Specification" session. The parameter is Enoa: noise at 1KHz.

0 Likes
Reply