cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

SampathS_11
Moderator
Moderator

 PSoC Programmer 3.22.3 is installed on Windows7, 64-bit. When trying to use MiniProg3, the failure message "SetLedState(..) failed in MiniProg3" is displayed.

   

Check if the MiniProg3 is connected to an USB3.0 Port. If so, move it to an USB 2.0 port, and it will start to work normally. This is because when MiniProg3 was designed, it was not qualified for USB3.0 compatibility.

0 Likes
1 Reply
himc_284346
New Contributor II

 Thank you for sharing this information.

0 Likes