Anonymous
Not applicable
Dec 25, 2013
09:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 25, 2013
09:15 PM
Dear all,
I'm doubt how can i correctly set the ports in project?dose there is a table to check?Like the UART ,read the data from SRAM to pc,so I should how to set the RX and TX?As also a RC filter,i have checked the Appendix,but i can't find the capacitor and resistor(except the potentiometer) corresponding ports signed on the paper.Thanks.
Labels
- Labels:
-
PSoC 5LP
5 Replies