I have successfully configured CY8CMBR3108 capsense chip using EZ-Click and CY3280-MBR3 dev kit. I effectively used the dev kit as a I2C bridge.
I would like to have a method of programming CY8CMBR3108 in production i.e. I don't want to give EZ-Click to production operatives because they could change the settings. I want to pass them only .hex or .iic file generated by EZ-Click.
What PC software should I use? I have tried Bridge Control Panel but without success. It allow me to open .hex file generated by EZ-Click and recognizes CY3280-MBR3 but it does not seem to be sending data to the target device. Also it allows for editing the configuration so it's not good.
I have also purchased MiniProg3 but it does not support capsense devices despite its datasheet suggesting it could be used as I2C bridge.
How to configure CY8CMBR3108 in production environment?
