cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

New to PSOC.  Hope this is right forum.

   

I got project CE95358 to work with Win 10.

   

 

   

I need it to work with Linux as the serial host.  Linux did not recognize the psoc 5lp device.  Is there a device driver that has to be installed on the Linux machine?

0 Likes
Reply
4 Replies
Valued Contributor

Hi, maybe this can help you (i haven´t try it but is the only info i found),check the comment on the bottom of the page

   

http://false.ekta.is/2015/08/cypress-cy8ckit-059-psoc-5lp-proto-kit-first-impressions/

   

 

   

Carlos

0 Likes
Reply
Anonymous
Not applicable

Thanks for input, but not quit there yet.

   

I tried 

   

sudo modprobe usbserial vendor=0x04B4 product=0xF139

   

minicom –baudrate 9600 –8bit –device /dev/ttyUSB1
#minicom –baudrate 9600 –8bit –device /dev/ttyUSB

   

It instanciated on debugging usb connector.  

   

Need to figure out uart bridging.

   

 

   

However, I was trying to get the usb connector that is on the other side of the board to instanciate, ie, the product usb connector.

   

Perhaps putting in the product codes for this usb may help.

0 Likes
Reply
Anonymous
Not applicable

Tried 

   

sudo modprobe usbserial vendor=0x04B4 product=0xF232

   

did not work.

   

Filed a problem with tech help.

   

Case # 3114776996

   

Will post what happens

   

Thanks for your help

0 Likes
Reply
Valued Contributor

Hi

   

I'm a "Linux" beginner so i tried to use the KitProg USB-UART bridge in Ubuntu 16.04.

   

After some googling i find out that an old driver (CyTherm) is loaded by the Linux kernel, so i did blacklist it, reboot the pc, and then Ubuntu recognize the UART bridge, i think it use libUSB driver now, can't remember i did this one month ago.

   

Today i wanted to use the USB-UART for first time so i plug the KitProg on the pc and did:

   

$ dmesg | grep tty

   

i get:

   

[ 4944.915562] cdc_acm 5-1:1.2: ttyACM0: USB ACM device

   

Then i used minicom to connect to it:

   

https://capa8net.wordpress.com/2014/02/08/conectar-al-puerto-consola-con-linux-y-minicom/

   

The post is in Spanish (my language) but you can follow it with the images, all is the same but instead ttyUSB0 you have to connect to ttyACM0.

   

It's seems working to me, hope it help you.

   

Carlos

0 Likes
Reply