I am trying to implement a low pass filter using the Psoc 5lp. I have watched the video titled "How to create an analog filter with Psoc 5lp" and am having trouble getting the same results as the video. With a filter gain of 0.5 (linear), the output signal is not matching the input signal in the pass band of the filter. In fact, the output is almost nothing. Has anyone had any issues with filtering using the Psoc 5lp? Any suggestions or sample programs would also be beneficial. Thank You all for your time.
Welcome in the forum, Corya!
Can you please post your complete project, so that we all can have a look at all of your settings? To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Although you are caring for positive input to the adc, the output of the filter will have negative values. You will need to add 128 to each of the samples from filter before sending them to VDAC.
By being new to cypress and the psoc lp5, do you have any suggestion on how to do this? Adding this factor of 128 was not shown in the tutorial video.
Converting an int8 from with the range of -128..+127 into an uint8 range 0..255 is done by adding 128 to the int8.
Hence you cannot do that using DMA, you need to pick the value from the filter, add 128 and send to DAC. Would need an interrupt or checking for a filtered value ready.
Hello Cory and Bob!
I am trying to implement the example program on my PSoC 5LP(CY8C5888LTI-LP097) as well. I currently am just trying to verify the operation of the example program by applying a 1Vpp sine wave with a 0.5V dc offset to the input. I am currently getting no signal on my oscilloscope from the output of the VDAC. I have uploaded the program I am currently running, which is essentially is just the example project.
Eventually I intend to use the filter for human voice range roughly 85-255Hz, but I just want to verify the operation of the example program first. Any help would be greatly appreciated!
Some scope pictures could help to see what's going on. I would suggest to increase the IMO frequency to 48MHz giving the interrupt handler some headroom.
Hello again Bob!
I have attached screenshots from the Oscilloscope to this message. The input signal is a 1Vpp sine wave with a 0.5 DC offset. The frequencies of the input screenshots are at 3kHz and 8kHz. Could you tell me where I would adjust the IMO frequency as well?
Just to be clear I am using the CY8CKIT-059 board with the CY8C5888LTI-LP097 chip. I just wanted to clarify that in case I may be using a wrong pin or that the board is incapable of performing this application.
Any help would be greatly appreciated! Thanks!
Do not use pin0_2. It is bypassed with a 1.0µF cap!
In view for assigning the pins, click on "Clocks" tab, then double click on IMO for settings