Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Hello, I am trying to control the speed of a brushless DC motor using an external electronic speed controller. The speed is determined by a signal from an RC device which I have been able to configure correctly to read the input and generate a measured pulse width (from 1ms to 2ms), using a timer configured for input capture. My only issue is outputting a signal to the ESC (requiring an 8kHz PWM signal) to drive the motor. I have attached part of my project for scrutiny and advise. Thank you.