- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. When write EEPROM :- 1. first EEPROM_Start() function call
2 EEPROM_UpdateTemperature() function which return non zero value. not gives zero value.
3. EEPROM_WriteByte(data, addr) return CYRET_UNKNOWN, if there was an SPC error.
please provide me solution as soon as possible
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
If you refer the DieTemp datasheet, it says after calling DieTemp_Start() you should wait for the DieTemp_Query() API to report the status of the request that is different from CYRET_STARTED. Please check you code and make sure you are doing this always after calling DieTemp_Start().
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, I am working with psoc5 lp (cy8c5267axi-lp051).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
resolve write problem but i have removed die temperature module from top design.
Is any method i use die temperature module at that time i am able to read and write in eeprom?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
If you refer the DieTemp datasheet, it says after calling DieTemp_Start() you should wait for the DieTemp_Query() API to report the status of the request that is different from CYRET_STARTED. Please check you code and make sure you are doing this always after calling DieTemp_Start().
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, it working