Anonymous
Not applicable
Jul 23, 2013
02:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 23, 2013
02:25 AM
I have herkulex motor(http://www.sgbotic.com/products/datasheets/robotics/herkulexeng.pdf)
I want to drive with psoc. There are 4 inputs on servo motor. 1-vcc 2-gnd 3- rx 4-tx . Can I drive the motor using uart in psoc. How should be uart parameters and code? Should I use half duplex full duplex uart? There is arduino library for motor. Can i import in psoc. There are several explanations in servo manual and I'm confused. How to write code for driving simply motor? Thanks..
Labels
- Labels:
-
PSoC 3
18 Replies