Sep 24, 2013
06:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2013
06:08 PM
Hi -- My kit worked fine last week. This week, I get the "device not recognized" message when programming. SQ
Labels
- Labels:
-
PSoC 1
2 Replies
Anonymous
Not applicable
Sep 24, 2013
06:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2013
06:36 PM
Hi SQ
Didn't you remove some stuff in accidentally?
Which module has the problem?
What's a building phase? Generate Configuration?
Can you roll back to the configuration at last week?
Need more information.
Didn't you remove some stuff in accidentally?
Which module has the problem?
What's a building phase? Generate Configuration?
Can you roll back to the configuration at last week?
Need more information.
Attachments are accessible only for community members.
Sep 24, 2013
08:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2013
08:08 PM
Some questions/thoughts -
1) Using Miniprog1 or ICE Cube ?
2) Project shows processor part number matches what you see in Programmer ?
3) If using Miniprog1 you have not altered the ISSP connections to PSOC, see schematic attached.
4) Correct setting for power to board in programmer ?
5) Any pins to PSOC outside supply rails in Voltage
Post project, that might help.
Regards, Dana.