Anonymous
Not applicable
Oct 20, 2014
08:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 20, 2014
08:06 PM
I have an unusual problem with reading the correct value from the CyResetStatus variable. I start the watchdog and then delay much longer than the alloted time. My system resets and I place a breakpoint on the first line in 'main'. I have a bootloader timeout of 2 seconds, which I assume is called but then resets the micro after the timeout is exceeded and places the program counter back to the application where my breakpoint is at.
I have read several docs that point me to using this variable, but the reset status variable always returns 0xA0? The top most bit is being set in the bootloader I think, but the watchdog timeout bit is never being set. Any ideas?
Thanks
Labels
- Labels:
-
PSoC 5LP
2 Replies