- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have an unusual problem with reading the correct value from the CyResetStatus variable. I start the watchdog and then delay much longer than the alloted time. My system resets and I place a breakpoint on the first line in 'main'. I have a bootloader timeout of 2 seconds, which I assume is called but then resets the micro after the timeout is exceeded and places the program counter back to the application where my breakpoint is at.
I have read several docs that point me to using this variable, but the reset status variable always returns 0xA0? The top most bit is being set in the bootloader I think, but the watchdog timeout bit is never being set. Any ideas?
Thanks
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am quite sure that you should place the breakpoint into the bootloader project. Another approach would be to save the CyTesetStatus in a global area accessible fromm bothm BootLoader and BootLoadable.
The second reset issued by the BootLoader will overwrite the initial reset-state.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yep, you're right. I placed the login inside of the bootloader project and everything worked fine.
Thanks