Mar 14, 2016
11:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 14, 2016
11:28 AM
Was working up to the point where I used the PSoC Programmer. The green LED was steady green. When I programmed, the programming failed and the device did not show up anymore in Device Manager. Now the green LED is steady for a second or so when I unplug and replug, then starts blinking rapidly. Have been using proper ESD procedures.
Does anybody have any suggestions?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 5LP
1 Solution
Mar 14, 2016
01:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 14, 2016
01:01 PM
Press the switch on the Kitprog for more than 5s. Green LED will light up steadily again.
Bob
1 Reply
Mar 14, 2016
01:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 14, 2016
01:01 PM
Press the switch on the Kitprog for more than 5s. Green LED will light up steadily again.
Bob