cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

I have two PSOC devices on a single board and I would ideally like to have a single programming connector that I can use to program either device.  I'm wondering if it would be sufficient to switch XRES (via jumper) to the device I would like to program and connect SWDIO/SWDCLK to both devices. 

0 Likes
2 Replies
EvPa_264126
Valued Contributor II

Yes, I disconnect the chip on the  boards CY8KIT-030, -50, -003, 014
Only XRES - enough.
http://mylab.wmsite.ru/moi-razrab/cypress-psoc/programmatory-iz-kitov/

0 Likes
Anonymous
Not applicable

Thanks! 

0 Likes