Jun 02, 2015
03:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 02, 2015
03:33 AM
I am a bit confused ovcer use of the EEPROM in the 5LP
Online examples state the entire rows must be read form eeprom, altered and written back. Hoewever, the datasheet for EEPROM in the schematic state you can read and write to any single byte using EEPEOM_ReadByte and EEPEOM_WriteByte.
Would someone please privide an example how I would write and read single bytes to EEPEOM.
Thanks
Labels
- Labels:
-
PSoC 5LP
3 Replies
Jun 02, 2015
04:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 02, 2015
04:20 AM
There is an example project for PSoC5LP and EEPROM that uses the ByteWrite() function.
Hope that this will clarify your doubts.
Bob
Jun 02, 2015
04:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 02, 2015
04:59 AM
Here is a component for that purpose -
http://www.psocdeveloper.com/project/easy-eeprom/
Regards, Dana.
Jun 09, 2015
12:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 09, 2015
12:34 PM