Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am working on the PSoC 5LP CY8C5888TPI-097 MCU galvanostat project, The project consists of a 3 Electrode system, to which
The constant current source is applied between the Working Electrode and the Counter Electrode.
The resultant voltage is measured between the Woking electrode and the Reference Electrode as shown in the figure.
Fig 1. Schematic diagram showing the three-electrode connection scheme between the electrochemical cell.
Fig 2 PSOC IDAC
For providing the constant current I am using IDAC and I am not finding a suitable example project on how the current source can be used between the two terminal devices with the PSoC examples. It will be really helpful if someone can guide me with how to deal with a current source in PSoC.
I came up with the following circuit connections, Is it the right way or any changes needed?