Anonymous
Not applicable
Aug 20, 2018
11:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 20, 2018
11:52 AM
Right now it is active low. So if the Host Interrupt is enabled, it is always high and pulses low when a cap signal changes state. It seems there is no way to change this on the cap-touch configurations, so I wanted to verify that. Can you not change the polarity of the Host Interrupt signal?
Solved! Go to Solution.
Labels
1 Solution
Aug 23, 2018
10:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 23, 2018
10:33 PM
Yes, I checked, the host interrupt polarity is not configurable.
Regards,
Bragadeesh
Regards,
Bragadeesh
Bragadeesh
4 Replies