Anonymous
Not applicable
Apr 25, 2018
09:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 25, 2018
09:32 AM
Hi All,
After one successful programming with my jtag, I'm not able to re-program my psoc5lp with it.
The error happen when doing step 3 Verify JTAG ID. In fact the APACC DATA Read never return the IDCODE now.
I'm using an on board ftdi as jtag programmer.
I'm playing SVF file generated with hex2svf tool in programmer folder.
There is a CPLD in the chain then the PSOC chip.
I'm able to read IDCODE using JTAG IDCODE state.
My configuration is still JTAG 4-wire as factory setting
Which register could I check with TC TAP to verify that Step 2 as been success fully executed ?
Regards,
Labels
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
3 Replies