cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

New Contributor II

Hi every one!!!

   

I have a question about the use of Psoc Creator and using the programmer 3.21.0.

   

I need to develop a board using the CY8C3866LTI-030.

   

It is supposed that the CY8CKIT-030 which has a CY8C3866AXI-040 is able to create  and debug code for any device of the family CY836XXXX.

   

When I am trying to build code there  no issue but ehen I want to download code for CY8C3866LTI-030 on a kit  a message appears telling me that is not target available for such a device.

   

Please someone tell me what is wrong with any of my statement.

   

 

   

Thank you very much.

   

Best regards

   

Alex101

0 Likes
Reply
4 Replies
Esteemed Contributor II

Since there are differences between the -030 and -040 chips (number of pins) the hex layout for the initial programming differs. So you have to select manually the correct device before you do a build.

   

 

   

Bob

0 Likes
Reply
New Contributor II

Thank you Bob!

   

I  select the device with de device selector, I layout the schematic,  I write down the code and everything is OK.

   

I build the project and all is find.

   

When I try to click on programmer icon  so I can run the code on the CY8C3866axi-040 a message appear telling me that there is no target matching the selected device.( in this case CY8C3866LTI-030)

   

I am trying to test  my code with CY8C-030 kit before download that code to 
CY8C3866LTI-030 on the Scmarboard.

   

Is it wrong what I want?

   

I am sure I am missing something but I cannot find what is this.

   

Thank you again.

   

Best regards,

   

Alex101

0 Likes
Reply
Esteemed Contributor II

You have to select the CY8C3866axi-040 device before building to let it run on your kit. You may change the device at any time using the menu item Project -> Device Selector...

   

 

   

Bob

0 Likes
Reply
New Contributor II

Ok, Thank you Bob.!!!!!

0 Likes
Reply