- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am using the CY8CKIT-001 kit.(chip cy8c5868AXI LP035) I want to use teraterm with uart. I'm programming it with a miniprog 3. Do I need to use another device for connection?so can i connect directly like in kit059?
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is not possible to use Teraterm using MiniProg3. CY8CKIT-001 has a level translator and a serial port connector J10. Kindly refer to page 57 on the kit guide, which shows how to use the on board serial port with a PC.
Additionally, the thread UART COM port using MiniProg3 maybe of interest to you.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is not possible to use Teraterm using MiniProg3. CY8CKIT-001 has a level translator and a serial port connector J10. Kindly refer to page 57 on the kit guide, which shows how to use the on board serial port with a PC.
Additionally, the thread UART COM port using MiniProg3 maybe of interest to you.
Best regards,
Sampath Selvaraj