Anonymous
Not applicable
Aug 09, 2010
10:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 09, 2010
10:16 AM
I'm trying to program the about chip with the MiniProg1 however I just get "FAILED! Can not Acquire Device! Please verify the device connection to the Programmer".
I'm using version 1.78 of the MiniProg firmware. Anyone else seen this problem??
Labels
- Labels:
-
PSoC 1
1 Reply
Anonymous
Not applicable
Aug 11, 2010
01:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 11, 2010
01:48 PM
I've seen that message before when I had my "Programming Mode" set to "Reset." Try setting it to "Power Cycle." The issue is, if it's set to Reset, the programmer wont supply any power to the chip, so it can't detect anything. On Power Cycle, it will supply power.