Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am looking to make the calls with my two PSoC 5LP cards using a 16x2 LCD display to be able to transmit and receive CAN bus messages as described in their application notes: EEOL_2009OCT09_INTD_AN_01 (AN52701) and 001-52701_AN52701_PSoC_3_and_PSoC_5LP_Getting_trans_Stand_Control.
How to connect my 2 16x2 LCD displays (pinout 1 to 14) and correctly configure my two PSoC 5LP (transmitter and receiver) to view the identical messages as they are in your application notes mentioned above? I will be using the same scheme as the second page of the application note: AN52701 according to the photo sent where I will use two TJA1050 transceivers together with my two PSoC 5LP as seen in another attached photo.
I would like some help to be able to develop my work.