Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Not applicable

There are four types of sensors that are commonly used for temperature measurement: Thermocouple, Thermistor, Resistance Temperature Detector (RTD) and diode. Of these, RTD has the best linearity and repeatability and is the sensor of choice when it comes to accurate temperature measurement in -200°C to 850°C range.


The resistance of an RTD varies with temperature in the following manner.



Once we find the resistance of the RTD, the temperature can be found using (inverse of) the above equations. But finding the inverse equation is very math intensive. The optimal approach is to determine the polynomial fit to find resistance from temperature. Using a higher order polynomial is computation intensive while using a lower order polynomial may not yield accurate results. AN70698 Temperature Measurement with RTDs provides a PSoC Creator Component for RTD where you can easily choose an appropriate polynomial based on your temperature range and accuracy required.





The PSoC Creator Component solves one part of the puzzle: converting the measured resistance accurately to temperature. The bigger part is finding the resistance accurately. AN70698 discusses the pros and cons of some circuits commonly used for measuring resistance and describes a method (shown below) where the resistance can be measured accurately using PSoC3/PSoC5 s IDAC, 20-bit delta sigma ADC and one precise external resistance.







The application note lists all significant sources of error so you know beforehand what accuracy to expect at a certain temperature.


Error Source

Error Value at 150 °C (0.1% Reference Resistor, class B RTD)

Error Value at 150°C (Both Reference Resistor and RTD Calibrated)

Offset Error/drift

0 °C

0 °C

Gain Error/drift

0 °C

0 °C


0.79 °C

0.79 °C

Error due to reference resistor (Ambient Temperature = 25 °C)

0.43 °C

limited only by calibration accuracy and reference resistor temperature coefficient(very accurate)

Error due to RTD interchangeability (Class B RTD)

1.05 °C

Limited only by calibration accuracy (very accurate)

Polynomial fit error (fifth-order polynomial)

0.0003 °C

0.0003 °C

RTD self-heating error

< 0.01 °C

<0.01 °C


Note(*): This error indicates the worst-case limit. The actual temperature error will be much lower, depending on the INL at that point. In most cases, the error will be < 0.1 °C.


Integrated 20-bit Delta Sigma ADC and IDAC combined with the RTD component simplifies designing with RTDs and gives you an experience no other design platform provides. PSoC3/PSoC5 also provides direct segment LCD drive for displaying temperature and a host of communication peripherals (I2C, SPI, UART, USB, SMBus, PMBus) for inter-IC communication or communication to a PC for data logging.

0 Replies