- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have a PSOC5 Prototyping kit (https://www.cypress.com/documentation/development-kitsboards/cy8ckit-059-psoc-5lp-prototyping-kit-on...) and I want to develop a robot based on that MCU. I need a 3D Model for this board in order to see if it fits in my enclosure.
I tried opening the .brd file in Allegro but the 3D model is unusable.
Where could I get a 3D model of it?
Thanks!
Solved! Go to Solution.
- Labels:
-
PSOC5 LP MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The dimensions of CY8CKIT-059 are Length - 120mm, Width - 30mm, Height - 10mm. These are approximate values, but the error is on the bigger side.
We do not have a 3D model file for this kit, since we did not intend for this kit to be used as a sub-assembly in another product. The .brd file is a PCB layout file, which can be opened in Allegro.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The dimensions of CY8CKIT-059 are Length - 120mm, Width - 30mm, Height - 10mm. These are approximate values, but the error is on the bigger side.
We do not have a 3D model file for this kit, since we did not intend for this kit to be used as a sub-assembly in another product. The .brd file is a PCB layout file, which can be opened in Allegro.
Best regards,
Sampath Selvaraj