- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Boris,
Have you tried to install additional devices using the menu "Tools->Find new devices"?
I am not installing additional devices due to some reasons.
Or "Tools->Find new components" may be effective to revise some components with new one.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Because CY8C4246AZI-M443 has three SCBs and SCB[3] cannot be assigned. Please refer the ordering information table on the "PSoC® 4: PSoC 4200M Datasheet"
It was found that all 48-TQFP packages have three SCBs. Please use 64-TQFP or 68-QFN.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Yes I know it has only 3 SCB, but only 2 are reachable.
SCB0 on port 1 or 4
SCB1 on port 0 or 2 or 3
SCB2: on port 5: not available on this model
SCB3: on port 6 or 7
How can I use the 3 SCB on this model?
Kind Regards,
Boris
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Boris,
I tried putting three EZI2C components only.
When built, PSoC Creator says there is no solution.
So, I recognized that this MPN cannot have three SCBs regardless of the datasheet description.
I don't know why SCB[3] is disabled instead of SCB[2] on this MPN.
Does anyone have an idea?
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Noriaki,
One of my collegue tryed it on his computer, and he succeded to use 3 SCB on the same PSoC.
The question is: why does it not work on my computer?
I have installed the last software (psoc Creator) downloaded on Cypress web site.
I didn't found where the MPN definition files are stored. Perhapst it is linked to such files.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Boris,
Have you tried to install additional devices using the menu "Tools->Find new devices"?
I am not installing additional devices due to some reasons.
Or "Tools->Find new components" may be effective to revise some components with new one.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Noriaki,
I tryed it. It seems not to have worked. I tryed the solution of Bibi. It worked.
I tryied to open my original project: now it works.
I think it was necessary to close the project and reopen after "find new device" operation.
Thank all lot (at all) for your help.
Kinds Regards,
Boris.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Boris.
To narrow down where the issue is, have your colleague archive the project and pass it to you. Then, open it on your computer.
Archiving a PSoC Creator Design
You can try all 3 different archive types (Minimal, Complete, Bundle) to see which one breaks down on your computer.
Hope this helps.
Bill