- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Cypress:
we choose CYBLE212020-01 for BLE passthorough , we just need the transmission the command with BLE, But we find CYBLE212020-01 is not the best module
for this application, and we can't fing AT command, file of BLE,Please help to advice it.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYBLE-212020 is a PSoC4BLE module which supports BLE 4.2.
I think it can satisfy your request if you just use it for BLE data transfer. This module has a EZ-Serial firmware with it which supports the AT command from UART. You can find the firmware and user guide about the AT command here: https://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform . Please refer to the user guide v1.1.1.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I guess you wanted to use the CYBLE-212020 as BLE controller correct?
CYBLE212020 supports BLE controller mode connected to host where the Host-controller interface is supported by UART (flow control can also be enabled).
Please refer Section F, Volume 6 of the BLE Spec 4.2 for the HCI commands. The spec is attached with this thread. You can use the template project Day18_Direct_Test_Mode from the link below:
PSoC-4-BLE/100_Projects_in_100_Days at master · cypresssemiconductorco/PSoC-4-BLE · GitHub
Please reply back if our understanding is not correct or if you need any other information.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYBLE-212020 is a PSoC4BLE module which supports BLE 4.2.
I think it can satisfy your request if you just use it for BLE data transfer. This module has a EZ-Serial firmware with it which supports the AT command from UART. You can find the firmware and user guide about the AT command here: https://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform . Please refer to the user guide v1.1.1.