- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone:
Electronics noob here. I want to read multiple analog sensor values using CYBLE-022001. I have six pressure sensors and I would like to read their values simultaneously or sequentially. The issue is that there are not enough pins on PROC. Could any one guide me in the right direction.
The pressure sensor I am using is: https://www.sparkfun.com/products/9673?_ga=2.131403334.874986698.1499420437-891638232.1499420437
Best,
Apoorva
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have two choices: Using external ADCs with I2C, SPI or UART interface or using a PSoC with more pins.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have two choices: Using external ADCs with I2C, SPI or UART interface or using a PSoC with more pins.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Bob. That was very helpful. I found some tutorials on that, and have started reading and implementing that.
Best,
Apoorva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Using an external mux to switch between sensors is also an option, as it would use 4 pins instead of 6+