cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

RaKu_3095736
New Contributor

hi all, I am counting square wave on pin no P4[5] or P4[4] based on rising edge or falling edge interrupt,

but it's not working on P4[5] or P4[4], the same code is working on any other pins

I am using PSOC4.2 and CY8C5268AXI-LP047TQFP-100-M

0 Likes
1 Solution
RaKu_3095736
New Contributor

I changed the drive mode of both the pins to high impedance digital and its start working

Thank you

View solution in original post

0 Likes
2 Replies
LinglingG_46
Moderator
Moderator

The two pins are GPIO.

Can you attached your test project here? Whether the Pin in your board has connected anything in your board? If so, remove them.

RaKu_3095736
New Contributor

I changed the drive mode of both the pins to high impedance digital and its start working

Thank you

View solution in original post

0 Likes