- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use an external 24Mhz crystal for the main oscillator on 4246AZI-L423 (attached to pins P7.0 and P7.1).
What settings do I need in the clocks section to use this as master clock?
Also, I want to generate a 31.25 kHz output continuously (derived from the master clock), do I just drop down a clock component and set F = 31.25Khz and attach it to a digital output pin? (I need an accuract clock for external device)
Thanks
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have changed the project configuration, I think it can meet your requirement now.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the example. I note the accuracy for 31.25kHz is displaying as +/- 5%?
I need the 31.25kHz signal around 100ppm.
I currently use a 4200 without external crystal but want to add the crystal specifically to get better accuracy on the 31.25kHz signal.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content