- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have issus when resetting my psoc 4200L BY8c4247bzI-L479
I can attach to the running target, see where I'm in stack traces etc (and obviously program etc) , but when I hit reset I get this:
PSoC Creatro Error dbg.M0007
The run request failed. Encountered error (Timeout of SROM polling. Lost communication with chip.)
All I get when searching for this is an issue that seems to be connected to 3.1 not 4.1 as I'm running.
Previously we used a L489 and it always worked.
Any ideas?
I'm pretty new to this debug environment, so I don't really know where to start looking. The project I have is massive, with freertos, usb type c etc, so it's a bit much to push over, however I could do that on the side if you really need that. or just point me to what you would need to shed any light on this.
Kind regards
Hjalmar
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Instead of the hardware reset button, can you use the "Debug->Reset" menu item or the "Reset" button on the toolbar?
The SWD communication may be disconnected by the hardware reset button.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Might be due to the complexity of the project. Is it possible to share your project.
Thanks
Jobin GT