cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

New Contributor

Hi  ,

     when I tuning  The BUTTON on  CY8C4014SXI-421,   I disable  IDAC  auto-calibration.  But  I can't change  parameters  like  "scan resolution, modulator IDAC . compensation IDAC".     It like  that  I had  enable  IDAC  auto-calibration.  please  help.

   thank you !

0 Likes
Reply
1 Solution
New Contributor II

Hi DIWE,

Did you unselected both IDAC calibration and IDAC compensation ?

unselect_idac_2.png

Hope it could help

View solution in original post

2 Replies
Moderator
Moderator

Hi Weidong,

Do you mean not able to change these paras in Tuner, could you share some screen snap shot of this issue?

If you are using Tuner, you can try choosing sync mode to watch data by Tuner.

0 Likes
Reply
New Contributor II

Hi DIWE,

Did you unselected both IDAC calibration and IDAC compensation ?

unselect_idac_2.png

Hope it could help

View solution in original post