Sep 03, 2019
09:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 03, 2019
09:01 PM
Hi ,
when I tuning The BUTTON on CY8C4014SXI-421, I disable IDAC auto-calibration. But I can't change parameters like "scan resolution, modulator IDAC . compensation IDAC". It like that I had enable IDAC auto-calibration. please help.
thank you !
Solved! Go to Solution.
Labels
1 Solution
Sep 05, 2019
05:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2019
05:20 AM
Hi DIWE,
Did you unselected both IDAC calibration and IDAC compensation ?
Hope it could help
2 Replies
Sep 04, 2019
07:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 04, 2019
07:59 PM
Hi Weidong,
Do you mean not able to change these paras in Tuner, could you share some screen snap shot of this issue?
If you are using Tuner, you can try choosing sync mode to watch data by Tuner.
Sep 05, 2019
05:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2019
05:20 AM
Hi DIWE,
Did you unselected both IDAC calibration and IDAC compensation ?
Hope it could help