PSoC™ 4 Forum Discussions
Hi,
I am looking for a standard i2c library for the CYBLE-022001-00 module. I have been using an RFduino for my project so far, and the Wire library (https://www.arduino.cc/en/Reference/Wire) has helped with this, but I cannot find anything for the CYBLE-022001-00 module. Any thoughts?
Show LessHi Folks,
I know that its not the most beautiful way to establish a SPI connection but due to Project history I have to implement an SPI bit banging method.
My Problem is now that the GPIO pins (even with fast slew rate) are too slow!
Do you know a way how I can get faster slew rates?
Thank you in advice.
Show LessThe Psoc evaluation board LED2 is keep on blinking ,once it powered up.I am unable to debug and psoc creator not showing any target device.
help me with this issue..
Show LessHi,
Just got the BLE KIT, and I am still exited with the fantastic KIT!
I finished the example of AN91267, Getting Started with PSoC® 4 BLE, however getting confused.
I am a newbie on PSoC, ARM, and bluetooth; trying to get data in Qt via BLE KIT. However, the firmware in the dongle is specially for CySmart.
Since the official firmware is .hex, is it possible that I may get an example c code or PSoC code to re-program the dongle and get data in Qt?
Thank you!
Show LessI would like to measure the pulse width of the signal. Time difference between rising edge and falling edge of the signal.
Can we implement this using one timer?
Nilesh.
Show LessOn this site is an app note AN92584.
It includes a ZIP with Excel to calculate power usage. But I cannot enter the payload despite the instructions saying you can.
Any ideas?
Thanks
Show LessThe questions about c11 (C version) and PSoC 4 is :
1º) I try to find information about the specific C language is valid for the PSoC, somebody have some thing ??
2º) How I active the C11 mode en PC Creator 3.3??
3º)How is the implementation for to the "pow" instruccion and "complex" number
Very thanks for your time
Show LessHi,
I want to send 512 bytes row data to PROC BLE by using the command "Write Long Characteristic Value" of CySmart,
when the AppCallback() function get a few "CYBLE_EVT_GATTS_PREP_WRITE_REQ",
the CySmart will get the error code : "BLE_GATT_ERR_PREPARE_WRITE_QUEUE_FULL".
How do I modify the queue size?
I tried to change the heap and stack size in cydwr (Design-Wide Resources) but it is not help!
Thanks!!
Aaron Deng
Show Less